![]() ![]() ![]() If you are not swapping the screen for an APIX 2 screen and sticking with the APIX 1 screen that came with your car, then that presents a couple of issues:ġst - you need to FDL code the headunit for APIX1 as after VO coding above, the screen will show "No Signal" - FDL code: Read ECU's, find the Headunit in the SVT list, right click on the folder and click "Code" - this will code the correct options of your car to the headunit. Go to the Expert > Coding Tab, read out your FA then edit and change the production date to 0317 (March 2017) You need to install the HU, write the VIN CPS to the HU using FSC extended, as above - this will be your own VIN from your car, the full 17 digits. I have a Harman Kardon system, does this need to be coded in the new headunit?ĭo I have to code which touch controller I have? I then just need to purchase FSC codes for my VIN on the new iDrive unit and inject?Īre there any other steps I need to include? I've found the below steps on the forum which are very useful from AMarston.ġ) Physically install the NBT EVO ID6 unit to the carĢ) Turn on the car ignition and open Esysģ) Open External Applications -> TransmitterĤ) Run the 'readVin' job to discover VINs against ECUsĨ) Use the WriteVIN job to update the vin of the donor HU with my own VIN I've connected to the car so know that is working fine. So I've installed esys and have the enet cable. Is this due to the ID version that's installed? Would it be better to buy a HW4.1 unit from another F chassis? I've seen a unit from a 2020 4 series, would there be any problems with this? I have read that it's better to look for a late 2018 version. I'm looking at changing the headunit to ID6 but I'm new to this and have a few questions. I have a 2016 330e F30 with a ID4 headunit, touch control and 8.8" screen with ATM. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |